■RF TRANSFORMER
Our RF transformer is based on a number of THAMWAY RF technologies.
Transformer classification varies according to purpose.
T011: STEP UP TRANSFORMER: Steps up the input signal
T012: ISOLATION TRANSFORMER: DC isolation between input and output,balance-unbalance conversion
T013: IMPEDANCE TRANSFORMER: Impedance matching in RF transmission lines:50Ω-75Ω conversion
T014: CURRENT SENSE TRANSFORMER: Current sensing

■WIDE BAND 90° HYBRID
An input signal is divided among 2, and it outputs by 90 deg of phase difference. Supporting the bands for 100kHz to 200MHz
In case that the upper limit frequency is under 10MHz, to be able to make decade band. And that the upper limit frequency is over 10MHz, to be able to make three octave band maximum.

■NARROW BAND 90° HYBRID
An input signal is divided among 2, and it outputs by 90 deg of phase difference.
Supporting the bands for 100kHz to 3GHz.

■FILTER (LPF,BPF,HPF,BEF)
THAMWAY designs and manufactures various filters such as the Low-Pass Filters, Band-Pass Filters, High-Pass Filters and Band-Elimination Filters.
Within our range of manufacturing, frequency of DC to 8GHz and RF power up to 10kW is possible.

■DIVIDER/COMBINER (0deg/180deg)
Our RF DIVIDER/COMBINER came about from a variety of THAMWAY RF systems and designs. Division and composition of RF POWER occurs at a low loss.
The product can be manufactured to specifications such as 0deg /180deg /2-way /4-way.

■DIRECTIONAL COUPLER
The DIRECTIOAL COUPLER developed from many of our RF systems. FWD and REV can be measured due to low loss.
It is possible to use it to measure power output and can be designed to conform to specifications.

■DOUBLE BALANCED MIXER (DBM)
The basic function of the DOUBLE BALANCED MIXER (DBM) is as an analog multiplier of two-input/one-output.
It multiplies on the temporalaxis when the RF signal is input to the RF terminal and the LO terminal respectively, and the frequency shift action is carried out as a result. Moreover, it becomes a gate circuit or an inverting circuit by inputting ON-OFF signals or a positive and negative two-pole signal to the IF terminal.
It aiso becomes an attenuation circuit by the DC voltage input to the IF terminal. It can be designed to client specifications.

■RF SWITCH
The RF-SW turns the input RF signal on and off at high speed according to the external control signal. It is used for the pulse modulator, etc. It can be designed to your specifications.

■RF ATTENUATOR
This is a voltage control-type variable attenuator composed of a pin diode. The amount of attenuation can be continuously changed by the external DC control voltage.

■PROGRAMMABLE ATTENUATOR
T133-201CA
The amount of attenuation can be set with the push button switch in 1dB steps, and this equipment can be set up to 45dB. It is very easy to use because the amount of attenuation that lights the push-button and the settings are displayed.
T133-401AA
This device alters the amount of attenuation between input and output of the 50Ω impedance system in 1dB increments viathe front panel key control or a GP-IB interface.