■NMR POWER AMPLIFIER (BIAS-GATE PULSE AMPLIFIER)
This device is designed to act as a high performance power amplifier for Nuclear Magnetic Resonance (NMR). It is an all solid-state high-speed pulse amplifier.
Low noise is achieved by adopting a bias gate system.

■PRE-AMPLIFIER
The preamplifier weak NMR signal at the initial stage of NMR scanning.

■DUPLEXER FOR NMR
It is possible to use as a transmit-receive switch when doing NMR scanning.
Because the leakage of the amplifier power to the receiver side can be reduced when transmitting, the effect on the receiver can be reduced.

■HETERODYNE RECEIVER
This is a double heterodyne receiver with low noise and large-signal gain designed for NMR measurement.
It is possible to use it through wideband without adjusting.

■BOXCAR (ANALOG AVERAGER)
The linear time invariant system is characterized by impulse response. If an input signal is periodic and its output signal is convolved with white noise, the N030-1014B can improve S/N by using the periodic signal synchronized with the input signal.

■UNIT TYPE RECEIVER
This receiver is divided into units of ①1'st Amp, ②2'nd Amp, ③PSD, ④DC-Amp, and ⑤REF-phase shifter. The frequency range of each unit can be extended if necessary.
It is very easy to use, and the price is low.

■NMR PULSE GENERATOR
The N210-1026E can set various pulse sequence with software on windows and communicate with a computer using a USB interface.
Because our AD board can be built into same BOX, automatic measurement can be enabled.

■TCP PROGRAMMABLE PULSE GENERATOR
The N120-1026T is suitable for systems that need various pulse sequences, such as NMR, ESR, and supersonic measurment.
Pulse conditions are set with TCP/IP. The N120-1026T can configure the sutomatic measurement system with external control software. The same commands as the Pulse generator N210-1026S can control the N120-1026T.

■IMPEDANCE ANALYZER
The impedance analyzer is designed for adjusting an NMR probe. Impedance matching conditions can be confirmed on a PC with the included software. Automatic measurement can also be possible owing to a built-in coaxial relay.
This device can be designed with wide range AC power input so that it is usable in any country.

■HIGH-SPEED A/D BOARD
The N230-1425A converts an input analogue signal into a digital signal and calculates it, offering high-speed performance. The N230-1425A communicates with a PC using a USB interface.
The N230-1425A can be built into the pulse generator N210-1026E.